Kubota — B Replacing Head Lamp

99 PERIODIC SERVICE C Air suspension seat B Replacing Head Lamp To avoid personal injury: A Be careful not to drop the bulb, hit anything against the lamp, apply excess force, and get the lamp scratched. If broken, glass may cause injury. Pay more attention to halogen lamps in particular, which have high pressure inside. A Before replacing the lamp, be sure to turn off the light and wait until the bulb cools down, otherwise, you may get burned. 1. While pushing the right and left lock buttons, pull and remove the electrical connector. 2. Remove the rubber boot. 3. Remove the clamping fixture and take out the bulb. 4.

Replace with a new bulb and reinstall the head lamp assembly in the reverse order. (1) Fuse (15 A) (2) Seat B Replacing Light Bulb 1. Head light Take the bulb out of the light body and replace with a new one. 2. Other lights Detach the lens and replace the bulb. (1) Electrical connector (2) Lock buttons (3) Rubber boot (4) Clamping fixture (5) Bulb (A)"Base's wider projection to face upward" A Be sure to use a new bulb of the specified wattage. A Never touch the bulb surface (glass) with bare hands. Fingerprints, for example, may break the bulb.

Light Capacity Head light 60 / 55 W Tail light 10 W Turn signal / hazard light (Front) 21 W Turn signal / hazard light (Rear) 21 W Brake stop light 21 W Front work light (Front side) 21 W Work light 55 W Dome light (room lamp) 10 W Sidemarker light 10 W