19 OPERATING THE TRACTOR C Weight and Height adjustment Turn on the key switch. The seat should be adjusted for the operator's weight by briefly pulling up or pushing down the weight / height adjust lever with the tractor in a stationary position and the operator sitting on the seat. The seat can be adjusted in its adjustable range. B Tilt Steering Adjustment To avoid personal injury: A Do not adjust the steering wheel while the tractor is in motion. A If the seat is lowered below the adjustable range, it automatically comes up to the lower limit of the adjustable range just when the weight / height adjust lever is released.
A When turning on the key switch, the seat may slightly move up depending on a preset seat position (height). Press down the steering wheel tilt pedal, to release the lock so the steering wheel can be adjusted to one of 7 desired positions. A In order to avoid damage of the seat, do not operate the weight / height adjust lever for more than 1 minute. C Tilt adjustment Pull the backrest tilt adjust lever and tilt the backrest to the desired position. C Arm rest Armrest may be set at upright position if desired. C Arm rest angle adjustment Turn the arm rest angle adjust knob to the desired angle.
A After adjusting the operator's seat, be sure to check to see that the seat is properly locked, (1) Steering wheel tilt pedal (A) "PRESS DOWN" 2. Selecting Light Switch Position. B Seat Belt B Light Switch Turn the light switch clockwise, and the following lights are activated on the switch position. To avoid personal injury or death: A Always use the seat belt when any ROPS or CAB are installed. OFF...... Head lights OFF. ....... Head lights dimmed, low beam. Adjust the seat belt for proper fit and connect the buckle. This seat belt is auto-locking retractable type. ....... Head lights ON, high beam. (1) Seat belt (1) Head light switch