36 PTO OPERATION B PTO Gear Shift Lever To avoid personal injury or death: A Disengage PTO, stop engine, and allow all rotating components to come to a complete stop before connecting, disconnecting, adjusting, or cleaning any PTO driven equipment. To avoid personal injury or death: A Be sure to observe the PTO shaft speed prescribed for the individual implements. It is extremely dangerous to run an implement at high speed that is meant to be operated at low speed. Use only when this higher rpm is specifically recommended by the implement manufacturer. B PTO Clutch Control Lever The PTO clutch control lever engages or disengages the PTO clutch which gives the PTO independent control.
Shift the lever to "ON" to engage the PTO clutch. Shift the lever to "OFF" to disengage the PTO clutch. The PTO gear shift lever can be set to either 540 rpm or 540E rpm positions. Move this lever to either position with the PTO clutch control lever set to "OFF". (1) PTO clutch control lever "ON" "OFF" (1) PTO gear shift lever (A) 540 rpm (B) 540E rpm (N) "NEUTRAL POSITION" A To avoid shock loads to the PTO, reduce engine speed when engaging the PTO, then open the throttle to the recommended speed. A To avoid damage of PTO clutch and implement, shift the PTO clutch control lever slowly, when engaging the PTO clutch. Do not keep the PTO clutch control lever half way.
Proper warm up is strongly recommended in cold weather. Do not continuously shift the PTO clutch control lever. A When light load, select the "540E" position for economical operation. A Tractor engine will not start if PTO clutch control lever is in the engaged "ON" position. A If the PTO system is engaged and you stand up from the seat, the warning buzzer will whistle for about 10 seconds after standing up. This is because the tractor is equipped with "Operator Presence Control System". 6 PT O PTO