Kubota — B Drawbar

39 3-POINT HITCH & DRAWBAR 3-POINT HITCH B Selecting the Top Link Mounting Holes Select the proper set of holes by referring to the "Hydraulic Control Unit Use Reference Chart" in Hydraulic Unit section. If the hydraulic unit is set for draft control, draft response is more sensitive when an implement is connected to the lower set of top link mounting holes. If draft control is not required, it is recommended to use the top set (1). 1 . Make preparations for attaching implement. B Selecting the holes of Lower Links There are 2 holes in the lower links. For most operations the lifting rods should be attached to the (B) hole. (1) Lower link (2) Lifting rod holes:

(A), (B) B Drawbar Remove the drawbar if a close mounted implement is attached. A The lifting rods may be attached to (A) for greater lifting force.