hitachi — Control by Electric and Hydraulic Combined Circuit

SYSTEM / Control System Lift Arm Kick-Out Control Purpose: Automatically to locate the lift arm at proper height when returning the lift arm to the highest position. Operation: 1. When lowering the lift arm, the plate is located in front of the lift arm proximity switch. When the plate is passing near the lift arm prox- imity switch, the lift arm proximity switch is turned ON. Therefore, the kick-out relay and the elec- tromagnet at the lift arm raise side are excited. 2.

When the lift arm control lever is moved farther than the lift arm raise detent position (position to pull farther than the raise position), the bucket control lever is retained by the electromagnet on the lift arm raise side, and pressure oil from the pilot valve moves the lift arm spool in the control valve to the raise side. 3. Pressure oil from the main pump flows to the bottom side of the lift cylinder through the lift arm spool in the control valve, and extends the lift arm cylinder. When the lift arm cylinder is extended, the plate also passes by the lift arm proximity switch. 4.

When the plate moves apart from the lift arm proximity switch, the lift arm proximity switch is turned OFF, and the electromagnet on the lift arm raise side is also turned OFF. This moves the lift arm control lever to the neutral position. As the lift arm spool in the control valve also returns to neutral, the lift arm cylinder stops. Consequently, the lift arm stops. T2-1-58