hitachi — Control by Electric and Hydraulic Combined Circuit

SYSTEM / Control System Lift Arm Auto-Leveler Downward Control (Op- tional) Purpose: To locate the lift arm between the horizon and the lowest position. Operation: 3. Pressure oil from the main pump flows to the rod side port of the lift cylinder through the lift arm spool in the control valve, and lowers the lift arm. 1. If the SET position of the lift arm auto-leveler downward set switch is selected after the lift arm is located within the allowable location of the lift arm auto-leveler (b’ in the illustration), the signal from the lift arm angle sensor is memorized by MC, and that is the lift arm auto-leveler downward stop position. 4.

When the lift arm angle sensor moves to the lift arm auto-leveler downward stop position, terminal B-22 of MC is not grounded, and the electro- magnet on the lift arm lowering side is unexcited for a while until it is excited again soon after. NOTE: When the lift arm is outside b’, although the SET position of the lift arm auto-leveler downward set switch is selected, the lift arm auto-leveler downward stop position cannot be set. In case setting was thus unsuccessful, or setting in a different posi- tion is needed, set the lift arm auto-leveler downward stop position again. 2.

When the lift arm auto-leveler downward switch is turned ON, terminal B-22 of MC is grounded, and excites the electromagnet on the lift arm down- ward side of the pilot valve. When the lift arm control lever is moved to the lift arm lowering de- tent position (position farther than the lowering position), the lift arm operation lever is retained by the electromagnet on the lift arm lowering side, and pressure oil from the pilot valve is supplied to the control valve. 5. Thus the lift arm control lever returns to the neu- tral position, and pilot pressure from the pilot valve stops flowing to the control valve. 6.

As the lift arm spool in the control valve also re- turns to neutral, the lift arm stops at the lift arm auto-leveler downward stop position. Position of Lift Arm Tip Pin Position of Lift Arm Foot Pin NOTE: In case the lift arm angle sensor is abnor- mal, the lift arm auto-leveler downward control is not made. IMPORTANT: In case either the lift arm angle sen- sor or MC has been replaced, make learning control of the lift arm angle sensor. (Refer to the OPERATIONAL PERFORMANCE TEST/Adjustment.) b’ (Lift Arm Auto-Leveler Downward Allowable Set- ting Range) b (Lift Arm Downward Work Range) T2-1-62