hitachi — Pilot Circuit

SYSTEM / Hydraulic System Brake Circuit Service Brake Circuit (Refer to the COMPONENT OPERATION / Charging Block group.) (Refer to the COMPONENT OPERATION / Brake Valve group.) Pressure oil from the pilot pump flows through the charging block, and is accumulated in the service brake accumulators. By stepping the brake pedal, pressure in the service brake accumulators is applied to the front brake and the rear brake through the brake valve, and actuates the service brake. When the brake pedal is stepped several times, pressure inside the service brake accumulators is lowered, and the relief valve is closed.

The priority valve spool moves rightward, and pressure in the service brake accumulators is kept constant by preferentially supplying pressure oil from the pilot pump to the service brake circuit, and firmly brakes the vihicle. Parking Brake Circuit Pressure oil from the pilot pump is applied to the parking brake solenoid valve in the charging block. When the parking brake is turned OFF, the parking brake solenoid valve is excited, and pressure oil entering the parking brake cylinder releases the parking brake. If the parking barke is turned ON, the parking brake solenoid valve is unexcited, and pressure oil stops supplying to the parking brake. Therefore the parking brake is applied.

Although pressure is lowered caused by damage of hose or something in the upstream of the parking brake solenoid valve, pressure for parking brake circuit is maintained for a while by the pilot accumulator. NOTE: The parking brake is released when the solenoid valve is excited. NOTE: The spring of the priority valve is adjusted so that the priority valve is not completely closed. Although the priority valve is closed completely, a certain amount of pressure oil is being supplied to the circuits downstream. NOTE: Although the engine is stopped, the service brake circuit pressure is retained for a while due to the functions of the service brake accumulators and the check valve. T2-3-22