SYSTEM / Hydraulic System STEERING CIRCUIT Normal Steering Circuit Normally, pressure oil from the main pump flows to the steering valve through the priority valve. As pilot line (LS2) is connected to the hydraulic oil tank, pressure is lost. The priority valve spool is moved to rightward pushed as pressure (LS1) from the own pump overcomes the spring force of the priority valve. Therefore, all pressure oil is supplied to the control valve. When the steering wheel is turned, the steering pilot valve spool is shifted, and pressure oil from the pilot pump moves the steering valve spool.
When the steering wheel is quickly turned, as a large amount of pilot pressure oil is supplied in a short period of time to the end of the steering valve spool through the steering pilot valve, the steering valve spool moves quickly and largely. When the steering wheel is slowly turned, as a small amount of pilot pressure oil is supplied gradually to the end of the steering valve spool through the steering pilot valve, the steering valve spool moves slowly and slightly. In proportion to the movement of the steering valve spool, pressure in pilot line (LS2) rises. Therefore, the priority valve spool is pushed leftward by the spring force of priority valve and pressure of pilot line (LS2).
In this way, pressure oil from the main pump flows to the steering cylinders through the priority valve and the steering valve, and the steering cylinders are actuated. (Refer to the COMPONENT OPERATION / Pump Device group.) NOTE: When pressure oil passes inside the steering pilot valve, pressure oil flows to the steering valve through the gerotor part. As the gerotor is connected to the middle shaft of the pilot steering valve, powered steering effect is generated. (Refer to the COMPONENT OPERATION / Steering Pilot Valve group.) T2-3-26