hitachi — Emergency Steering Check Circuit (Optional)

SYSTEM / Electrical System EMERGENCY STEERING CHECK CIRCUIT (OPTIONAL) (Manual Check Circuit) When the key switch is turned to the ON position, current from terminal M excites the battery relay. The battery power enters the emergency steering relay through fuse #6 of fuse box B and also enters terminal B of the emergency steering pump unit. When the emergency steering check switch is turned to the ON position, current flows to terminal 1-14 of the monitor unit. At the same time, as the monitor unit grounds terminal 2-11, the emergency steering relay is excited. The power enters terminal C of the emergency steering pump unit through the emergency steering relay.

The power excites terminal B and the emergency steering pump unit is started. IMPORTANT: The emergency steering pump unit is not designed in order to be operated for a long time. When its operation has been confirmed, turn the emergency steering check switch OFF by stopping pushing the switch. (Auto Check Circuit) When the engine is started by turning the key switch to the ST position, the alternator starts generating electricity. When part of the electricity generating signal from terminal L of the alternator enters the monitor unit and increases to the specified voltage, terminal 2-11 of the monitor unit is grounded, and the emergency steering relay is excited.

The power enters terminal C of the emergency steering pump unit through the emergency steering relay. The power excites terminal B and the emergency steering pump unit is started. The emergency steering pump unit works for several seconds, and then the ground circuit of terminal 2-11 of the monitor unit is automatically released. Therefore, the emergency steering pump unit stops. If hydraulic pressure higher than the specified value is delivered during operation of the emergency steering pump unit, the emergency steering pump delivery pressure switch is turned OFF, and the automatic inspection operation is stopped normally.

If hydraulic pressure higher than the specified value is not delivered, the emergency steering pump delivery pressure switch is kept ON. The emergency steering operation warning lamp on the monitor unit blinks in order to notify that the emergency steering pump unit is abnormal. T2-4-32