COMPONENT OPERATION / Pump Device Increase and Decrease Operations of Delivery Flow The displacement angle of swash plate (4) is changed by the movement of servo piston 1 (3) and servo piston 2 (6). Movement of the servo piston is controlled by the regulator. The feedback of the swash plate movement is given to the regulator by feedback lever (7) and link (8). 7 8 6 3 4 NOTE: Refer to the following pages as for operation of the regulator. Tilting Change Operation Tilting center of the swash plate is located at A in the drawings right. Pilot pressure is always applied to servo piston 2 (6).
Therefore, when the circuit of servo piston 1 (3) is connected to the hydraulic oil tank, swash plate (4) tilts clockwise around A. Conversely, as there are two servo pistons 1 (3), when pilot pressure is applied to both of servo piston 1 (3) and servo piston 2 (6), swash plate (4) tilts counterclockwise around A. Feedback Operation End of feedback lever (7) is inserted into the projection on the side of swash plate (4). When swash plate (4) tilts, the projection also moves, and feedback lever (7) moves together. For example, if swash plate (4) tilts to the maximum displacement angle position from the minimum displacement angle position, the center of feedback lever (7) moves from B to C.
This movement of feedback lever (7) moves link (8), and feedback is given to the regulator. T4GB-03-01-022 Minimum Displacement Angle: 6 3 4 T4GB-03-01-023 Maximum Displacement Angle: Housing 8 7 A 4 T4GB-03-01-024 Housing Projection C B T3-1-3 A A