hitachi — Operation

COMPONENT OPERATION / Pilot Valve During Metering or Pressure Decrease Full Stroke 1. When the control lever is further tilted, the ouput port is connected to port P via the fine control hole on spool (7). 2. Pressure oil of port P flows into the output port through spool (7) and pressure at the output port is raised. 3. Pressure at the output port acts on spool (7) and tends to push spool (7) upward. 4. In case the force pushing spool (7) upward is smaller than the spring force of balance spring (5), balance spring (5) is not compressed. Therefore, port P and the output port remain connected, and pressure at the output port keeps rising. 5.

When pressure at the output port rises further, the force pushing spool (7) upward increases. If this force becomes larger than the force of balance spring (5), spool (7) moves upward by compressing balance spring (5). 6. When spool (7) moves upward, the output port is not connected to port P and pressure oil stops flowing from port P to the output port. And pressure increase at the output port is stopped. 7. In this way, balance spring (5) is compressed by the amount spool (7) is pushed downward, and pressure at the output port is the balanced pressure acting on spool (7) and the spring force. 1.

When the control lever is fully stroked, disc (7) pushes push rod (2) and piston (3) downward, and spring guide (4) pushes spool (7) downward. 2. The output port is connected to port P via the fine control hole on spool (7). 3. As spool (7) is pushed down by spring guide (4), the output port remains connected via the fine control hole of spool (7) although pressure at the output port is raised and as spool (7) does not move upward. 4. Consequently, pressure at the output port side is equal to pressure at port P. T3-6-10