hitachi — Operation

COMPONENT OPERATION / Pilot Valve OPERATION At Neutral (Pusher Stroke: Between A and B) 1. At the neutral position of the control lever, spool (7) completely blocks pressure oil of port P. As the outlet port is connected to port T through the notch part of spool (7), pressure at the output port is equal to pressure in the hydraulic oil tank. 2. When the control lever is moved slightly, cam (1) is tilted, and pusher (2) and spring guide (4) are pushed in. Pusher (2) and spring guide (4) remain mutually connected, move downward while compressing return spring (6). 3. At this time, spool (7) is pushed by balance spring (5) and moves downward until the clearance in part A becomes zero. 4.

During this movement, the output port remains connected with port T and pressure oil is not supplied to the output port. 5. When pressure at the output port rises further, the force pushing spool (7) upward increases. If this force becomes larger than the force of balance spring (5), spool (7) moves upwards by compressing balance spring (5). 6. When spool (7) moves upward, notch part (B) closes and pressure oil stops flowing from port P to the output port. And pressure increase at the output port is stopped. 7.

In this way, balance spring (5) is compressed by the amount spool (7) is pushed downward, and pressure at the output port is the balanced pressure acting on spool (7) and the spring force. NOTE: The lever stroke during the period when part A becomes zero is the play of the control lever. During Metering or Pressure Decrease (In Pusher Stroke: Between C and D) Pilot Pressure D 1. When the control lever is further tilted, the hole part on spool (7) is connected to notch part (B). 2. Pressure oil of port P flows into the output port through notch part (B) and the hole part on spool (7), and pressure at the output port is raised. 3.

Pressure at the output port acts on the bottom of spool (7) and tends to push spool (7) upward. 4. In case the force pushing spool (7) upward is smaller than the spring force of balance spring (5), balance spring (5) is not compressed. Therefore, port P and the output port remain connected, and pressure at the output port keeps rising. C B A Pusher Stroke T1F3-03-09-004 Output Diagram T3-6-14