COMPONENT OPERATION / Pilot Valve During Metering or Pressure Decrease (Output Diagram: Between C and D) 1. When the control lever is further tilted and pusher (2) is pushed down, hole part (7) on spool (6) reaches port P and pressure oil of port P flows into the output port. 2. Pressure at the output port acts on the bottom of spool (6) and tends to push spool (6) upward. 3. In case the force acting on spool (6) is smaller than the spring force of balance spring (4), balance spring (4) is not compressed. Therefore, spool (6) is not pushed upward, and pressure at the output port keeps rising. 4. When pressure at the output port rises further, the force pushing spool (6) upward increases.
If this force becomes larger than the force of balance spring (4), spool (6) moves upward by compressing balance spring (4). 5. When spool (6) moves upward, hole part (7) closes, pressure oil stops flowing from port P to the output port, and pressure increase at the output port is stopped. 6. In this way, balance spring (4) is compressed by the amount spool (6) is pushed downward, and pressure at the output port is the balanced pressure acting on spool (6) and the spring force. F E D C B A Lever Stroke T523-02-05-001 Output Diagram T3-6-20 Pilo Pre t ssure