SYSTEM / Control System Engine Torque Control Purpose: To improve fuel consumption rate by changing the torque curve in response to the input signals from the work mode selector switch, shift switch and vehicle speed sen- sor Operation: Engine Torque 1 2 1. When MC receives the signal of the selected work mode, MC detects the shift point. 2. MC has programmed torque curves to be se- lected in response to the combination of work mode and speed shift. MC outputs the selection command signal most suitable to each time to ECM . When light mode (L) is selected, torque curve 1 or 2 is used. When normal mode (N) or power mode (P) is se- lected, torque curve 1 is used. 3.
ECM carries out alteration control of torque curves in response to the input torque curve se- lection command signal. Engine Speed Conceptual Diagram of Engine Torque Curve NOTE: In case the signal from the work mode se- lector switch is not transmitted to MC, backup control that the work mode is fixed to the normal mode is made. NOTE: In case the signal from the shift switch is not transmitted to MC, backup control that Torque Curve 1 is selected is made. NOTE: Each mode switch of the work mode se- lector switch is supplied with different volt- ages for each from the monitor unit. When the switch selects a mode, MC judges which mode has been selected by the input voltage. NOTE:
The shift switch has two switches, and the combination of their ON varies depending on each speed shift. The controller judges which speed shift has been selected by the combination of the two input signals. T2-1-12