SYSTEM / Control System Manual Speed Shift Control Purpose: To shift the speed manually Operation: 1. When manual (M) of the travel mode switch is selected, MC is provided with voltage of 1V. 2. The manual speed shift program is started in MC. 3. The shift switch is a rotary type and has two switches inside. When one of a speed among speed 1 through speed 4 is selected, the signal of the selected shift position is transmitted to MC according to the combination of ON of the shift switches. NOTE: MC is programmed in order to dtermine the vehicle speed ranges to change to the re- spective speed shifts. NOTE:
When the shift switch is turned from speed 3 to speed 1 while traveling, the vehicle automatically shifts down to speed 2, and then shifts down to speed 1 after the vehicle speed becomes the range of speed 1. NOTE: In case a malfunction occurs in either so- lenoid valve of speed 1, speed 3, or speed 4, the vehicle speed is fixed at speed 2. In case a malfunction occurs in either the forward clutch solenoid valve or reverse clutch solenoid valve, or speed 2 solenoid valve, only the abnormal one cannot be used. Speed Shift Speed 4 Internal Switch 1 ON Internal Switch 2 ON 4. MC transmits the signal to the speed shift solenoid valve for the selected speed. 5.
If forward or reverse of the FNR lever or the FNR switch is selected, traveling is started when the accelerator pedal is depressed. 6. When the vehicle speed reaches the set speed for the selected speed shift, MC transmits the signal to the speed shift solenoid valve for the selected speed. NOTE: In case the speed shift is raised, the se- lected speed shift is immediately obtained regardless of the vehicle speed. NOTE: The shift switch has two switches, and the combination of their ON varies depending on each speed shift. The controller judges which speed shift has been selected by the combination of the two input signals. NOTE: The FNR switch does not transmit the neu- tral signal.
In case of no electric current from the FNR switch, the controller judges that the switch is neutral (N). NOTE: Each mode switch of the travel mode switch is supplied with respectively different volt- ages from the monitor unit, and if a switch is selected, MC judges which mode has been selected. NOTE: The speed shift selected by the shift switch is the highest speed shift. T2-1-28 Speed 1 Speed 2 Speed 3 ON ON