hitachi — Transmission Control

SYSTEM / Control System Automatic Speed Shift Control Purpose: To shift the speed automatically with three kinds of timing selection of automatic speed shift change Operation: 1. If either of 1-4L, 2-4N and 1-4H of the travel mode switch is selected, MC is supplied with votage according to the selected mode. 4. MC transmits the signal to the speed shift solenoid valve in response to the output value each time of the torque converter input speed sensor, torque converter output speed sensor, vehicle speed sensor and accelerater pedal sensor. MC eventu- ally makes speed shift control until the selected speed shift. NOTE:

Each shift position specifies necessary ve- hicle speed and accelerator pedal output value that allows shifting change to its posi- tion. The setting parameter is programmed in MC. Thus, when the travel mode switch is set in auto 1-4L and the shift switch is set in speed 3, the vehicle starts with speed 2, and then shifts up speed 3 according to the acceleration of the vehicle speed. On the other hand, when the shift switch is changed from speed 3 to speed 1 while traveling, the vehicle shifts down to speed 2 automatically, and then shifts down speed 1 if the vehicle speed reduces in the range of speed 1. 2. MC starts the selected automatic speed shift pro- gram.

The vehicle starts with speed 2 in auto 1-4L control, and it automatically be shifted down to speed 1 if travel load is too high. In this mode, the vehicle shifts at early timing during low engine speed. The vehicle starts with speed 2 in auto 2-4N control. In this mode, the vehicle shifts at higher engine speed than auto 1-4L control. The vehicle starts with speed 2 in auto 1-4H control, and it automatically be shifted down to speed 1 if travel load is too high. In this mode, the vehicle shifts at higher engine speed than auto 1-4L control. NOTE: In case the travel mode switch becomes out of order, MC makes speed shift control in the manual traveling mode. NOTE:

Even if a mode of 1-4L, 2-4N, or 1-4H is selected, the vehicle starts with speed 1 if the shift switch is selected. 3. The shift switch is a rotary type and has two switches inside. When a speed shift is selected among speed 1 through speed 4, the selected shift signal is transmitted to MC according to the combination of ON in the shift switch. NOTE: In case a malfunction occurs in either so- lenoid valve of speed 1, speed 3, or speed 4, the vehicle speed fixed is at speed 2. In case a malfunction occurs in either of the forward clutch solenoid valve, reverse clutch solenoid valve, or speed 2 solenoid valve, only the abnormal one cannot be used. NOTE:

In case a malfunction occurs in the vehicle speed sensor, the vehicle speed is detected by using the transmission middle shaft sensor, which may have large margin error. In case a malfunction occurs in both vehicle speed sensor and the transmission middle shaft sensor, the vehicle speed is fixed at speed 2. NOTE: The speed shift selected by the shift switch is the highest speed shift. T2-1-30 Mode Auto 1-4L Auto 2-4N Auto 1-4H Output Voltage 2 V 3 V 4 V Speed Shift Speed 1 Speed 2 Speed 3 Speed 4 Internal Switch 1 ON ON Internal Switch 2 ON ON