hitachi — Transmission Control

SYSTEM / Control System Downshift Control Purpose: To lower the speed shift by pushing the switch installed at the right console. Operation: 8. In case of the following, the downshift switch con- trol is canceled. Operation of the FNR lever or the FNR switch Operation of the shift switch Operation of the travel mode switch Pushing the hold switch (Only in auto mode of the travel mode switch) 1. When traveling at speed 4 while the travel mode switch is set in auto 1-4L mode, the signal is transmitted to MC by pushing the downshift switch once. 2. When the vehicle speed is faster than the allow- able speed to shift down, MC cancels the signal from the downshift switch.

On the other hand, MC transmits a signal to the speed shift solenoid valve of speed 3 when the vehicle speed is slow enough. NOTE: In case the vehicle speed sensor becomes abnormal, MC receives the signal from the transmission middle shaft sensor, and con- trols by calculating the vehicle speed al- lowable for the speed shift. In case both the vehicle speed sensor and the transmission middle shaft sensor are abnormal, lowering the speed shift is possible as an emergency measure only when the engine stops for one reason or another but traveling is not stopped. 3. When the downshift switch is pushed while the vehicle speed is slow enough to shift down, speed 2 is selected. 4.

In case auto mode of the travel mode switch is selected, auto speed shift control is recovered three seconds after the speed shift has lowered, and then the speed shift is automatically raised once the vehicle speed increases. NOTE: The shift switch has two switches, and their combination of ON varies depending on each speed shift. The controller judges which speed shift has been selected by the combination of the two input signals. 5. When the downshift switch is continue to be pushed, the speed shift is lowered to speed 2, and speed 2 is kept during pushing. 6.

At this time, when the downshift switch is released and pushed again within three seconds while the vehicle speed is slow enough to shift down, the vehicle shifts to speed 1. NOTE: The FNR switch does not transmit the neu- tral signal. In case of no electric current from the FNR switch, the controller judges that the switch is neutral (N). 7. When the downshift switch is in the manual mode of the travel mode switch, in case the vehicle speed is slow enough to shift down, the speed shift is lowered and the shifted speed is kept. NOTE:

Each mode switch of the travel mode switch is supplied with respectively different volt- ages from the monitor unit, and when the switch selects a mode, MC judges which mode has been selected by the input volt- age. T2-1-32