SYSTEM / Control System Upshift Control Purpose: To raise the speed shift by putting the left hand on the steering wheel and pushing the switch installed at the right console Operation: NOTE: The shift switch has two switches, and their combination of ON varies depending on each speed shift. The controller judges which speed shift has been selected by the combination of the two input signals. 1. MC receives a signal by pushing the upshift switch once when traveling with speed 1 while the travel mode switch is set in auto 1-4L mode and the shift switch is set in speed 4. 2. MC transmits the signal to the speed shift solenoid valve of speed 2, and shifts up the vehicle speed. 3.
When the upshift switch is pushed, the vehicle speed is further raised to speed 3 and speed 4. 4. In case auto of the travel mode switch is selected, the speed shift is raised, and returned to the auto speed shift control in three seconds, eventually raising automatically to the speed shift selected in advance. 5. In case manual of the travel mode switch is se- lected, the raised speed shift is kept. 6. In case of the following, the upshift switch control is canceled. Operation of the FNR lever or the FNR switch Operation of the shift switch Operation of the travel mode switch Pushing the hold switch (only when the auto mode of the travel mode switch is selected) NOTE:
The FNR switch does not transmit the neu- tral signal. In case of no electric current from the FNR switch, the controller judges that the switch is neutral (N). NOTE: Each mode switch of the travel mode switch is supplied with respectively different volt- ages from the monitor unit, and when the switch selects a mode MC judges which mode has been selected by the input volt- age. NOTE: Althrough the upshift switch is pushed while traveling at the speed shift slected by the shift switch, the speed shift is not raised further. T2-1-34