SYSTEM / Control System Clutch Cut Control Purpose: To release the FNR clutch of the transmis- sion in order to make the most of the engine torque by operating the brake during opera- tion of the front attachment. Depressing amount of stepping the brake at the time of declutching can be selected from among three kinds depending on the op- erator’s preference. Operation: 5. In case the brake pressure is lowered below the set pressure by reducing the depressing amount of the brake pedal, the signal transmitted to the clutch solenoid valve is raised again, and clutch- ing is made. NOTE:
In case either of the clutch cut position switch and brake pressure sensor becomes out of order, clutch cut control is not made. 1. When either mode of the clutch cut position switch is selected, voltage according to the selected mode is transmitted to MC. NOTE: Each mode switch of the clutch cut position switch is supplied with respectively different voltages from the monitor unit, and when the switch selects a mode, MC judges which mode has been selected by the input voltage. 2. MC starts the corresponding clutch cut control program. Clutch cut is not made in OFF mode.
In mode S, clutch cut is made at output voltage of the brake pressure sensor beyond the set pressure of mode S, and clutching is made again at output voltage below that of mode S. In mode N, clutch cut is made at output voltage of the brake pressure sensor beyond the set pressure of mode N, and clutching is made again at output voltage below that of mode N. In mode D, clutch cut is made at output voltage of the brake pressure sensor beyond the set pressure of mode D, and clutching is made again at output voltage below that of mode D. 3. In case the brake pedal is depressed in mode S, the signal from the brake pressure sensor is transmitted to MC. 4.
When the signal is higher than the set voltage, MC declutches by lowering the signal transmitted to the excited solenoid valve among the respective solenoid valves. T2-1-36 Mode OFF S N D Input Voltage 1 V 2 V 3 V 4 V