SYSTEM / Control System Speed Shift Holding Control Purpose: To hold the speed shift while towing or trav- eling uphill. Operation: NOTE: The shift switch has two switches, and their combination of ON varies depending on each speed shift. The controller judges which speed shift has been selected by the combination of the two input signals. 1. When the hold switch is pushed once, the signal is transmitted to MC. 2. MC continues to transmit the signal to the speed shift solenoid valve of each time, and after that, the speed shift is fixed although if the accelerator pedal or the brake pedal is depressed. NOTE: The FNR switch does not transmit the neu- tral signal.
In case of no electric current from the FNR switch, the controller judges that the switch is neutral (N). NOTE: The speed shift holding control is made only when auto (1-4L, 2-4N, or 1-4H) of the travel mode switch is selected. 3. MC releases the speed shift holding control in case the following switches operations are made. Turning the key switch OFF Pushing the hold switch again Downshift switch Upshift switch FNR lever FNR selector switch (only when effective) FNR switch (only when effective) Speed shift switch Travel mode switch Parking brake switch NOTE:
Each mode switch of the travel mode switch is supplied with respectively different volt- ages from the monitor unit, and if a switch is selected, MC judges which mode has been selected. T2-1-38