SYSTEM / Control System Hydraulic Fan Cooling Control Purpose: To improve fuel consumption rate and noise reduction by restricting the hydraulic fan speed in response to each oil temperature and coolant temperature. Operation: 1. When the engine is started, the fan pump rotates and delivers oil to the fan motor. 2. MC receives the signals from the hydraulic oil temperature sensor, engine coolant temperature sensor and torque converter oil temperature sensor at the same time, and calculates three target hydraulic fan speeds. 3. MC selects the fastest speed, and transmits the signal to the flow rate control solenoid valve. 4. The flow rate control solenoid valve is operated.
As pressure oil from the flow rate control solenoid valve flows into the right end of the flow rate con- trol valve, the flow rate control valve spool moves to the left. 5. When the flow rate control valve spool moves to the left, as a part of pressure oil to the fan motor flows to the tank port, the fan motor speed is low- ered accordingly. 6. In case either oil temperature or coolant tem- perature is above the set temperature, the hy- draulic fan speed is maximum when the engine speed is maximum. 7. In case either oil temperature or coolant tem- perature is below the set temperature, the hy- draulic fan speed is lowered in response to the data of the highest temperature. 8.
As, the signal from the fresh air temperature sensor also enters MC, the fan is always rotated at the maximum speed while disregarding the controls in 2 to 7 in case the air conditioner switch is ON at the fresh air temperature of 35 ° C (95 ° F) and above. NOTE: In case any of the engine speed sensor, hydraulic oil temperature sensor, engine coolant temperature sensor, torque con- verter oil temperature sensor or fresh air temperature sensor is abnormal, hydraulic fan cooling control is always made at the maximum speed. T2-1-42