hitachi — Other Controls

SYSTEM / Control System Hydraulic Fan Cleaning Control Purpose: To clean the radiator and oil cooler by re- versing the hydraulic fan in order to blow away dust in case cleaning of the radiator and oil cooler are needed. Operation: NOTE: Temporarily turn the reverse rotation control solenoid valve ON when the key switch is turned ON as the spool maybe stuck in case the reverse rotation control solenoid valve is not operated for a long time. It is turned ON once every one minute after the key switch is turned ON. This operation is not made during the hydraulic fan cleaning control. 1.

When the engine is started after the following conditions exist and the fan reverse rotation switch is turned ON, the signal is transmitted from MC to the reverse rotation control solenoid valve. 2. When the reverse rotation control solenoid valve is operated, the reverse rotation spool is shifted, and the fan motor rotation is reversed. 3. In reverse rotation, as hydraulic fan cooling con- trol is not made, the fan speed changes from maximum to minimum in response to the de- pressing amount of the accelerator pedal. 4. In case any one of the following conditions are changed during reverse rotation, the engine speed is immediately fixed to idle speed. 5.

Hydraulic fan cleaning control is not released only by turning the fan reverse rotation switch OFF. This control is released by the procedure of turn- ing the fan reverse rotation switch OFF – turning the key switch OFF – turning the key switch ON. 6. In case the engine speed is fixed to idle speed, this control is released by the procedure of turning the fan reverse rotation switch OFF – turning the key switch OFF – turning the key switch ON. Conditions: Fan reverse rotation switch: ON Parking brake switch: ON (Brake is effective.) FNR lever: neutral FNR switch: neutral T2-1-44