Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika piping and condenser’s neck. LP rotor is aligned for turbine operation. potrubн a nбstavby kondenzбtoru. NT rotor je vyrovnбn na provoz turbнny. ATTENTION: Below described assembly work can be carried out only after the embedding of pedestals into grout and after the final TG alignment not earlier then 2 months before turbine start-up (forming of the concrete foundation). UPOZORNĚNH: Nнže popsanй montбžnн operac e provбdějte až po provedenн zбlivky a po konečnйm vyrovnбnн TG nejdřнve 2 měsнce před najнžděnнm turbiny na otбčky (tvarovбnн betonovйho zбkladu).
IP turbine casing will be assembled before expedicion in the factory DSPW, including right position of stator flow part and gland of rotor. Water pressure test of tightness is carry- out separately on outer casing. IP turbine casing is sent dismantled on site, as parts (list boxes for transport is contained in chapter 2.3.) Bottom and top part of IP outer casing is transported by parting plane down. Nozzle extensions are screwed on cover of casing for transport. Hanging points and manipulation with casing is specified in chapter no. 2.5. Hanging ropes are delivered for manipulation with assembled upper of casings acc. to drawing Tp6070205.
ST těleso turbiny bude před expedicн kompletně smontovбno ve vэrobnнm zбvodě DSPW , včetně sprбvnйho ustavenн statorovэch dнlů průtočnй čбsti a ucpбvek rotoru. Na vnějšнm tělese je samostatně provedena vodnн tlakovб zkouška těsnosti. ST těleso turbiny je na staveniště odeslбno rozebranй, po dнlech (seznam beden pro dopravu je uveden v kapitole č.2.3.) Spodnн i vrchnн čбst S T vnějšнho tělesa je transportovбna dělнсн rovinou dolů. Dэzovй nбstavce jsou přišroubovбny na vнku tělesa pro dopravu. Zбvěsnй body a manipulace s tělesy je specifikovбna v kap. č.2.5. Pro manipulaci se smontova nэmi svršky těles jsou dodбna zбvěsnб lana, dle vэkresu Tp6070205.
Prepare the adjustable supporting wedges Tp318707 and put them on the bearing stands. Připravte stavěсн klнny Tp318707 a uložte je na ložiskovй stojany. Date: 12.11.2013 Page 166 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ 2.11.3 Assembly of the turbine IP casing delivered as parts / Montáž ST tělesa turbíny dodaného po dílech