DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Turning gear with its servomotor will be tested on the testing stand of producer before transport to the site. Turning gear with its electric motor will be transported inside the wooden box separately from turbine bearing stand. The drawing of the turning gear is Tp066332 . · Check the state of turning gear after transport. Assemble the turning gear to the cover of bearing stand; check the clearance between gearing of pinion pos. 7 and the geared rim of LP turbine rotor by means of the feeler gauge.

Set the parallelism of the teeth of rim and pinion, set the backlash in gearing by underlying of turning gear on cover of bearing stand or by machining of spacer there has to be kept blacklash from 0,3 up to 0,35 mm . Assemble the servomotor Tp066350 and accessories of turning gear Tp6021685 if not assembled yet from producer. · Before the final assembly, seal the parting plane, flanges and bushings by means of suitable sealing paste (Novato TL350). · Test the function and easy running by hand and then with power supply (moving the wheel in the mesh, turning with rotor).

· Fix the mutual position between the turning gear and the flange of the bearing stand’s cover by drilling of 2pcs of taper pins, tighten the flange’s nuts. · Natбčedlo a jeho servopohon bud ou před dopravou na staveniště zkoušen y na testovacнm pultu vэrobce. Natбčedlo bude přepraveno v dřevěnй bedně s namontovanэm elektromotorem odděleně od ložiskovйho stojanu turbнny. Vэkres natбčed la je na Tp066332 . · Zkontrolujte stav natбčedla po přepravě. Montujte natбčedlo na vнko ložiskovйho stojanu, kontrolujte vůli v ozubenн pastorku poz. 7 s ozubenэm věncem NT rotoru turbiny spбroměrkou.

Nastavit rovnoběžnost zubů věnce a pastorku, vůli v ozubenн nastavit podloženнm natбčedla na vнku ložiskovйho stojanu nebo opracovбnнm mezikusu – vůle musн bэt dodržena v rozmezн 0,3 až 0,35 mm . Montujte servopohon Tp066350 a p řнslušenstvн natбčedla Tp6021685 , pokud nenн již namontovбno od vэrobce. · Před konečnou montбžн těsněte dělнсн rovinu, přнruby a průchodky pomocн vhodnй těsnнcн pasty (Novato TL350). · Proveďte zkoušku funkce natбčedla ručně i elektricky (zasouvбnн do zбběru, otбčenн rotorem). · Zafixujte polohu natбčedla vůči přнrubě vнka ložiskovйho stojanu zavrtбnнm 2x kuželovэ kolнk, dotahujte matice přнruby. Date: 12.11.2013 Page 222 / 278 Prepared: O.Baroch Last Revision:

Approved: P.Lešetickэ 2.11.10 Assembly of the turbine turning gear / Montáž natáčedla turbíny