DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

BANDEL STEAM TURBINE 210 MW - SCREW / BOLTґs TIGHTENING Screw & Bolts & Nuts arrangement: § Washing of preservation off (petrol), deburring, checking of free turning in thread (nuts on bolt / screw), perfect degreasing by acetone. § Application of the sliding lack (if pre-scribed) into thread of bolt/screw + nuts and onto the contact face of the nut - all just before their installation. Letting the lack drying for at least 24 hours in a dust-free place. § Application of the anti-sizing lubricating compound with sufficient thermal resistance into thread of bolt/screw + nuts and onto the contact face of the nut before the nut assembly onto the bolt / screw. !! ATTENTION:

Use exclusively the lubricating means which are pre- scribed in ŠKODA drawings !! Sliding lack: Molykote D321R Anti-sizing compound for extremely stressed bolt joints with the high thermal resistance: Molykote G Rapid + (up to 450°C) or GLEIT - µ HP 505 (up to 1200°C) Bolts / Screw tightening in the Flange Joints: Bolts / screws tightening in flanges at high-pressure joints have to be done together with checking of the circumference gap between the hubs of both counter-flanges. During the tightening there must not arise such deformation which can cause leakage in the contact surface. 1) COUPLING BOLTS:

Coupling bolts tightening is evaluated according to the boltsґ extension - so it is necessary to properly measure the length of bolts in free condition just before their installation (micrometer) to be possible to compare it during tightening. The bolts extension can be achieved by impact-wrench or easily by means of the torque machine with the torque control - equal torque is written below. Sockets for the castle nut are available on power plant: Castle end / Inner square 1" Castle end / Hexagon 65 mm 2) HP outer TURBINE CASING : Scope of the tightening by preheating:

Install the bolts with nuts, tighten the nuts by impact wrenches to put it into full contact with flange, check if also parting plane of flange is in proper contact, mark mutual position of both nuts onto flanges and on bolt, mark the prescribed nut-turn angle on flange by Date: 9.8.2013 The last revision: 16.9.2013 Page no.: 2 of 9 Worked out by: O.

Baroch ŠKODA COUPLING Æ BODY of Amount THREAD of NUT TORQUE REQUIRED SOCKET TORQUE HEAD Varnish COUPLING CASTLE Drawing no ESTIMATION BOLT (AVAILABLE) SPECIFICATION BOLT NUT EXTENSION HP-IP turbine rotor Æ44 G6 20 M 42 x 3 Tp6019459 4100 Nm 0,22 ± 0,02 mm Castle end / Inner square 1" Square drive 1" NO IP-LP turbine rotor Æ65G6 16 M 60 x 4 Tp6076929 11700 Nm 0,37 ± 0,03 mm Castle end / Hexagon 65 mm Ring Cassette type with inner hexagon 65 mm NO LP turbine- Generator rotor Æ70 G6 16 M 64 x 4 Tp6078820 12900 Nm 0,41 ± 0,03 mm ??