D 2011 Job card overview TD 2011 Sorted numerically 5 © 01/2009 OBJ_DOKU-24383-001.fm 7/8 Job card Activity Maintenance group W 00-02-06 Checking the compression pressure General W 00-05-01 Mounting engine on assembly block and demoun- ting General W 01-01-01 Setting valve clearance Cylinder head W 01-02-02 Removing and installing the rocker arm and rocker arm bracket Cylinder head W 02-02-02 Renewing the crankshaft sealing ring (flywheel side) Drive system W 02-02-04 Renewing the crankshaft sealing ring (opposite side to flywheel) Drive system W 03-01-11 Removing and installing the crankcase bleeding Crankcase W 03-09-01 Removing and installing rear cover Crankcase W 03-09-04 Removing and installing the connection housing Crankcase W 04-03-01 Renew camshaft sealing ring (opposite side to fly- wheel) Engine control W 04-04-11 Steuerzeiten prüfen Engine control W 04-04-12 Renew toothed belt and tensioning pulley Engine control W 04-04-15 Removing and installing the toothed belt wheel Engine control W 05-07-01 Removing and installing the impulse transmitter Speed control W 06-01-05 Removing and installing the exhaust line Exhaust system/Charging W 06-01-05 Removing and installing the exhaust damper Exhaust system/Charging W 06-02-03 Removing and install the charge air line Exhaust system/Charging W 06-06-04 Removing and installing the turbocharger Exhaust system/Charging W 06-07-03 Removing and installing the intake manifold Exhaust system/Charging W 06-09-06 Removing and installing the exhaust gas return val- ve Exhaust system/Charging W 06-09-07 Removing and installing the exhaust gas return pipe Exhaust system/Charging W 06-09-08 Removing and installing the exhaust gas collection pipe (Exhaust gas recirculation) Exhaust system/Charging W 06-09-09 Removing and installing the sensor (Exhaust gas recirculation) Exhaust system/Charging W 06-09-10 Removing and installing the magnet clip (Exhaust gas recirculation) Exhaust system/Charging W 07-02-07 Removing and installing the lifting magnet (Start amount release) Fuel system W 07-03-01 Renewing the injection lines Fuel system W 07-04-01 Removing and installing the fuel injector pump Fuel system W 07-06-01 Check start of injection Fuel system W 07-06-03 Calculating the thickness of shim Fuel system W 07-07-01 Removing and installing the fuel injectors Fuel system