Deutz — Setting valve clearance

D 2011 Cylinder head TD 2011 W 01-01-01 Valve clearance setting schematic D 2011 According to the order given below, the setting of the valve clearance is possible in two turns of the crankshaft (each 360°). Crankshaft position 1 ●Turn over crankshaft until the valve overlap is achieved on cylinder 1. ●Set black marked valves. 6 Crankshaft position 2 ●Turn the crankshaft one turn (360°). © 25894-5 ●Set black marked valves. TD 2011 Valve overlap: Outlet valve is not yet closed, inlet valve begins to open. When the outlet valve is fully open, the inlet valve opens briefly approx. 2 mm. This is not the valve overlap! ●Clean sealing surfaces. ●Mount new gasket. Note installation position:

The bar (1) must face the front cover. 1 © 47500-0 © 01/2009 OBJ_DOKU-23458-001.fm 4/6 Valves Cylinders overlap 1 3 4 2 set to 4 2 1 3