29 EXCAVATOR OPERATION EXCAVATOR OPERATION RUNNING-IN OF THE NEW EXCAVATOR The operation and care of the new excavator influences its life span. Your new excavator has been carefully checked and tested before leaving the factory. In spite of this, all movable components must run-in during the first 50 work hours. Do not work with full rpm's and full loads during this period. It is very important to run-in your excavator properly in order to achieve its full performance and longevity. During the running-in, the following points should be adhered to in all cases. B Adjusting the Operator's Seat To avoid personal injury: A Make sure that the seat is completely secured after each adjustment.
B Do not Work with Full Engine Rpm's or Full Loads during the First 50 Working Hours A Let the engine warm up sufficiently in the cold season. A Do not let the engine rev-up more than necessary. B Oil Change in the Run-in Stage The lubrication oil plays a specific and important role during the run-in phase of the excavator. The numerous movable parts are not yet run-in, so many fine metal particles are generated, which can cause damage and shorten the life of many components. Pay attention to the oil-change intervals and complete them sooner than later. See "REGULAR CHECKS AND MAINTENANCE WORK" section for more details on the oil-change intervals.
(1) Backrest tilt adjust lever (2) Travel adjust lever (3) Weight adjust lever (A) "UNLOCK" (B) "UNLOCK" (C) "TO INCREASE TENSION" (D) "TO DECREASE TENSION" C Tilt adjustment Pull the backrest tilt adjust lever in the direction of [A] and move the backrest to the desired angle. C Travel adjustment Pull the travel adjust lever in the direction of [B] and slide the seat backward or forward, as required. The seat will lock in position when the lever is released. C Weight adjustment Turn the weight adjust lever to achieve the optimum suspension setting. C Height adjustment Lift the seat to the desired height of the three available positions.
Adjust the seat to the desired position after lifting the seat to the highest position in the case of lowering the seat.