Operation 4 4.3 Engine 4.3.1 Starting Attention Each time before putting the machine into operation, the inspections according to ( О 7.8, 76) must be carried out. Danger to life due to presence in the danger zone. Before switching on the engine always ensure that no-one is in the danger zone of the machine. All gearshift levers to neutral. Parking brake selector switch (10/54) in position ON, travel direction preselector (10/7; 10/36) in position "0". 21 22 P 31 Insert ignition key in glow plug and starter switch (10/61). + - 00014,0 h 12 Km/h 0 4/4 1/2 Hot start Switch on ignition and wait for approx. 5 sec. Attention The display establishes the internal readiness for operation.
All indicator lamps are briefly activated for a functional check. 36 3 + - P 00014,0 h 12 Km/h The indicator lamps (10/22, 10/31) light up. 0 4/4 1/2 Press the accelerator pedal (10/3) completely down for normal start and to the quarter-open position for hot start. 7 After the indicator lamp (10/21) has gone out, turn the glow plug and starter switch to "START". As soon as the engine is running, turn the ignition key to “1” and decrease the revs to low idle speed. The indicator lamps should go out. 54 If the engine has not started after max. 20 seconds, turn the ignition key to “1” or “0”, and pause for at least 1 minute before trying again. Repeat the start-up procedure.
61 Engine damage Avoid damaging the engine by: Fig. 10 Starting the engine not driving the engine at full throttle straight away. driving with restraint until the engine has reached its operating temperature. 40/112 TL160 Operating Manual 12.9.08 Version 1.0