Care and Maintenance 7 7.5 Care and cleaning 7.6 Notes for winter operation Attention The following points - and the relevant notes in the Engine Instruction Book - should be observed during winter operation: The machine must be cleaned on a suitable surface with an oil separator. Neither a steam-jet appliance nor a high-pressure cleaning apparatus may be used for cleaning during the first two months after the machine has been used for the first time, or when newly painted, to ensure that the paint can harden sufficiently. Hydraulic oil If the machine is not used for longer periods at temperatures around and below freezing, warm it up by running the engine at medium speed (approx.
3 – 5 min). Do not use aggressive detergents for cleaning the machine. We recommend using commercially available cleaning agents for passenger cars. Engine oil When cleaning with a steam-jet appliance, the hot water jet should not exceed 80 °C and a spray pressure of 70 bar. The oil viscosity (SAE class) should be selected according to the ambient temperature at the machine's place of operation. Linings (insulating materials, etc.) should not be exposed directly to water, steam or high-pressure jets. Coolant Before the beginning of the cold season, check the level of antifreeze and adjust in line with the ambient temperature if necessary.
At the factory, the antifreeze protection is set to approx. -25 °C. When cleaning with water or steam jets, take care not to spray exhaust-gas and air filter openings. When cleaning the engine with water or steam jets, do not expose sensitive engine parts, such as generators, cabling, oil pressure switches, etc. directly to the jet. Condition of the battery A good cold start performance requires a well- charged battery. By warming the battery to approx. +20 °C (remove the battery after the engine has been turned off and store it in a warm room), the minimum starting temperatures can be lowered by 4 – 5 °C.
After each wet clean, the machine must be lubricated in accordance with the lubricating plan and a test of all work cycles, support and driving functions carried out. When installing the battery, ensure good contact of terminal connections. Only tighten terminal screws so that they are "hand-tight", to prevent deformation of the terminal cones. 66/112 TL160 Operating Manual 12.9.08 Version 1.0