Komatsu — 3.9.1 LOADING AND UNLOADING THE MACHINE

TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9 TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9.1 LOADING AND UNLOADING THE MACHINE q The procedures to be followed to use any control sy- stems different from the ISO and OPTION PATTERNS are described in section "OPTIONAL EQUIPMENT" (See "6.5 HAND & FOOT CONTROL SYSTEM"). Carefully read and be sure to understand the contents of this section before using the machine. q The loading and unloading of the machine on/from the means of transport must be carried out on a flat surface and at a safety distance from the edges of ditches or from roadsides. q Block the means of transport by positioning wedges be- fore and behind each wheel.

q Make sure that the ramps have the same length, are fir- mly anchored to the vehicle, are parallel to each other and perpendicular to the loading board; the distance between the ramps must be suitable for the machine gauge. q Assicurarsi che le rampe siano di pari lunghezza, siano fermamente ancorate all’automezzo, siano parallele fra loro e perpendicolari alla sponda di carico; I’interasse deve essere adatto alla carreggiata della macchina. q Position the ramps with a maximum inclination of 15є°. q Remove any trace of oil, grease or ice from the ramps and the loading board.

q Do not change direction when the machine is already on the ramps; if necessary, go down and find the correct di- rection. 127 CAUTION WARNING