USING THE WORK EQUIPMENT 3.13.6.3 CHECKING THE POSITION OF THE LOCKING PINS The position of the pins (1) must be checked with the levers in locked or horizontal position. The length of the protruding part of the pins must be in compliance with the prescribed values, as indicated in the figure. To check the length of the protruding part of the pins, proceed as follows: 1 - Slowly raise the arm. 2 - Rotate the bucket or the equipment forward, until the pro- truding part of the pins can be seen by the operator with no need to leave his seat. 3 - If the length (1) is not within the specified range of values, adjust it by proceeding as indicated in paragraph "3.13.6.4 ADJUSTING THE LOCKING PINS".
1 43±2 RWA36370 141