MAINTENANCE NOTES 4.2.4 NOTES REGARDING LUBRICATION q Lubrication makes the operations carried out with the machine and work equipment smoother, while preventing wear and the noise that may be produced if the articulated joints are dry. Lubrication is to be carried out with grease or oil. q The maintenance operations required for the components that need lubricating are the following: 1 - check of the levels; 2 - oil change; 3 - injection of grease through the grease nipples. q Use only the specified lubricants, according to the ambient temperature.
q Always clean the grease nipples before injecting grease and remove any excess grease after lubrication; this cleaning operation must be performed with extreme care on the revolving parts. q Keep the lubricants at the correct levels; excessive or insufficient quantities are to be avoided. 4.2.5 PARTS SUBJECT TO WEAR THAT PERIODICALLY NEED CHANGING The parts subject to wear such as filters, bucket teeth, etc. must be replaced according to the periodic maintenan- ce intervals prescribed or when they reach the wear limit. The timely change of these parts ensures an economic use of the machine. Use only Komatsu genuine parts, which alone can guarantee excellent quality and interchangeability.
158 PARTICOLARE CODICE DENOMINAZIONE Q.tà FREQUENZA DI SOSTITUZIONE Engine oil filter YM129150-35151 Cartridge 1 EVERY 250 HOURS Hydraulic oil filter 37C-62-13420 Cartridge (drain) 1 EVERY 500 HOURS Fuel filter YM123907-55800 Cartridge 1 EVERY 500 HOURS Air cleaner YM129935-12520 YM119160-12570 Main cartridge Safety cartridge 1 1 WHEN REQUIRED WHEN REQUIRED Front bucket 825010053 801015574 801920106 Tooth Screw Nut 6 12 12 — — —