CHANGING THE AUTHORIZED EQUIPMENT 6.2.2 CONNECTING THE HYDRAULIC CIRCUIT q Before performing any operation on the hydraulic circuit, stop the engine and eliminate the residual pressures from the equipment circuits by operating the controls more than once, then lock the safety bars (see "3.3.5 pos. 1 - SAFETY BARS"). q Immediately clean any area dirty with oil. After the mechanical connection of equipment with indepen- dent hydraulic circuit, make sure that the auxiliary kit control pedal is in position A - flow interrupted - and introduce the flexible pipes of the equipment connection in the unions (1) and (2).
See B,C and D The rapid coupling must be in compliance with the ISO 8434-3 standard. IMPORTANT q In case of doubts regarding the connection of the hy- draulic circuit to the equipment, contact your Komatsu Dealer 1" UNS 1 2 1" UNS RWA36090 213 WARNING