Komatsu — 6.4.1 HOW TO CHANGE THE OPERAT ING PATTERN

CHANGING THE OPERATING PATTERN 6.4.1 HOW TO CHANGE THE OPERAT- ING PATTERN After stopping the machine on a firm and level surface, lower the equipment to the ground, stop the engine and lock the con- trols by lifting the safety bars in vertical position. Open the engine hood and proceed as follows: 1 - Loosen the safety screw (3) that holds the selection lever (2) in position. Use a 13 mm hexagon wrench. 2 - Select the desired operating pattern by rotating the lever (2) to position " A " for the ISO PATTERN or to position " B " for the OPTION PATTERN. 3 - Secure the lever in the selected position with the safety screw (3).

IMPORTANT q Before moving the machine, the operator must make su- re that the selected operating pattern corresponds to the one desired. The control panels (4) positioned at the sides of the cen- tral dashboard are backlit. q The lighting of the plates is useful for the operator to identify the type of operating system selected. (ISO PAT- TERN or OPTION PATTERN control system). 220