QSB4.5 and QSB6.7 Air Compressor Discharge Lines Section 7 - Maintenance Procedures at 2000 Hours or 2 Years Page 7-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Air Compressor Discharge Lines General Information All air compressors have a small amount of lubricating oil carryover that lubricates the piston rings and moving parts. When this lubricating oil is exposed to normal air compressor operating temperatures over time, the lubricating oil will form varnish or carbon deposits.
If the following maintenance check are not performed, the air compressor piston rings will wear and not seal correctly. Maintenance Check Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING Shut off the engine. Open the drain valve on the wet tank to release the system air pressure. Remove the air compressor discharge line from the air compressor. Location of the air compressor discharge line can be found in Flow Diagram, Compressed Air System in System Diagrams (Section D).