Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-12 Section TS - Troubleshooting Symptoms Coolant Loss - External Cause Correction STEP 1 Coolant level is below specification ............. Inspect the engine and cooling system for external coolant leaks. Repair if necessary. Add coolant. Refer to the OEM service manual. OK Go To Next Step Inspect the engine for coolant leaking from hoses, draincocks, water manifold, jumper tubes, expansion and pipe plugs, fittings, radiator core, air compressor and cylinder head gaskets, lubricating oil cooler, water pump seal, cylinder block, and OEM-mounted components that have coolant flow. Refer to Section A.
STEP 2 External coolant leak ............. OK Go To Next Step STEP 3 Radiator cap is not correct, is malfunctioning, or ............. Check the radiator pressure cap. Refer to the OEM service manual. has low-pressure rating OK Go To Next Step STEP 4 Cooling system hose is collapsed, restricted, or ............. Inspect the hoses. Refer to Section 4. leaking OK Go To Next Step STEP 5 Coolant fill line is restricted or obstructed ............. Check the coolant fill line for restrictions or obstructions. Refer to Section 7. OK Go To Next Step STEP 6 Coolant is rusty and has debris ............. Drain and flush the cooling system. Fill with correct mixture of antifreeze and water.
Refer to Section 7. OK Go To Next Step Refer to the Coolant Temperature is Above Normal - Sudden Overheat or the Coolant Temperature is Above Normal - Gradual Overheat symptom tree. STEP 7 Engine is overheating ............. OK Go To Next Step STEP 8 Contact a Cummins® Authorized Repair Facility