Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-24 Section TS - Troubleshooting Symptoms Engine Noise Excessive Cause Correction STEP 1 Fan drive belt is loose, tight, or not in alignment ............. Check the fan drive belt. Refer to Section 3 . OK Go To Next Step Refer to the Lubricating Oil Specifications in Section V. If the oil pressure is low, refer to the Lubricating Oil Pressure Low troubleshooting symptom tree in Section TS. STEP 2 Lubricating oil is thin or diluted ............. OK Go To Next Step STEP 3 Vibration damper is damaged or loose ............. Inspect the vibration damper. Contact a Cummins® Authorized Repair Location.
OK Go To Next Step STEP 4 Air intake or exhaust leaks ............. Check for loose or damaged piping connections and missing pipe plugs. Check the turbocharger and exhaust manifold mounting. Refer to Section 3 . OK Go To Next Step STEP 5 Air intake or exhaust piping is contacting the ............. Inspect the air piping, chassis, and cab for contact points. Refer to the OEM service manual. chassis or cab OK Go To Next Step STEP 6 Air intake system restriction is above specification ............. Check the air intake system for restrictions. Clean or replace the air filter and inlet piping as necessary. Refer to Section 4 .
OK Go To Next Step Refer to the Coolant Temperature is Above Normal - Sudden Overheator the Coolant Temperature is Above Normal - Gradual Overheat symptom tree. STEP 7 Coolant temperature is above specification ............. OK Go To Next Step STEP 8 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step STEP 9 Fan clutch, hydraulic pump, or refrigerant compressor noise is excessive ............. Isolate each component and check for noise. Refer to the OEM service manual. OK Go To Next Step