Cummins — 4021531

QSB4.5 and QSB6.7 Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-27 Engine Power Output Low Cause Correction STEP 1 Electronic fault codes are active ............. For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. OK Go To Next Step STEP 2 Fuel grade is not correct for the application or the ............. Operate the engine from a tank of high-quality fuel. Refer to Fuel Recommendations and Specifications in Section V. fuel quality is poor OK Go To Next Step STEP 3 Engine is operating above recommended altitude .............

Engine power decreases above recommended altitude. Refer to the OEM's altitude operation guidelines.. OK Go To Next Step Compare the tachometer reading with a handheld tachometer or an electronic service tool reading. Calibrate or replace the tachometer as necessary. Refer to the OEM service manual. STEP 4 Tachometer is not calibrated or is malfunctioning ............. OK Go To Next Step STEP 5 Intake and exhaust system restricted ............. Check the intake and exhaust systems for restrictions. Inspect the intake air filter and replace as necessary. OK Go To Next Step Check the air intake system for restriction. Clean or replace the air filter and inlet piping as necessary.

Refer to Section 4. STEP 6 Air intake system restriction is above specification ............. OK Go To Next Step Check for loose or damaged piping connections and missing pipe plugs. Check the turbocharger and exhaust manifold mounting. Refer to Section 4. STEP 7 Air intake or exhaust leaks ............. OK Go To Next Step Check for leaks in the air crossover tube, charge air cooler connections, hoses, or through holes in the manifold cover and repair or replace if necessary. Refer to the OEM service manual. STEP 8 Air leak between the turbocharger and the intake ............. manifold OK Go To Next Step