Cummins — 4021531

Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-42 Section TS - Troubleshooting Symptoms Engine Will Not Reach Rated Speed (RPM) Cause Correction STEP 1 Electronic fault codes are active ............. For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. OK Go To Next Step STEP 2 Vehicle speed is too low for adequate cooling with ............. Reduce the engine load. Increase the engine (fan) rpm by downshifting. high engine load OK Go To Next Step Compare the tachometer reading with a handheld tachometer or an electronic service tool reading. Calibrate or replace the tachometer as necessary.

Refer to the OEM service manual. STEP 3 Tachometer is not calibrated or is malfunctioning ............. OK Go To Next Step STEP 4 Air-fuel tube leaking, wastegate diaphragm ............. Tighten the fittings, repair plumbing, replace wastegate diaphragm. Refer to the OEM service manual or an Authorized Cummins Repair Facility. ruptured, or wastegate plumbing damaged OK Go To Next Step Inspect the air cooler for internal and external restrictions. Replace the restricted cooler if necessary. Refer to the OEM service manual. STEP 5 Charge air cooler restricted (if equipped) ............. OK Go To Next Step Check the flow through the filter to locate the source of the restriction.

Refer to the OEM service manual. STEP 6 Fuel supply is not adequate ............. OK Go To Next Step STEP 7 Exhaust back pressure too high ............. Measure and correct if above specification. Refer to an Authorized Cummins Repair Facility. OK Go To Next Step Check the fuel lift pump for correct operation. Check the pump output pressure. Replace the fuel lift pump if necessary. Refer to an Authorized Cummins Repair Facility. STEP 8 Fuel lift pump is malfunctioning ............. OK Go To Next Step