Cummins — 4021531

Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-58 Section TS - Troubleshooting Symptoms Lubricating Oil Pressure Low Cause Correction STEP 1 Engine angularity during operation exceeds specification ............. Refer to the Engine Data Sheet. OK Go To Next Step STEP 2 Lubricating oil does not meet specifications for ............. Change the oil and filters. Refer to Section 5. Use the oil recommended in Section V. operating conditions OK Go To Next Step Check for a missing dipstick, rain caps, or oil fill caps. Change the oil. Refer to the OEM service manual. STEP 3 Lubricating oil is diluted with water .............

OK Go To Next Step STEP 4 Lubricating oil filter is plugged ............. Change the oil and filter. Refer to Section 5. Use the oil recommended in Section V. OK Go To Next Step STEP 5 Lubricating oil is contaminated with coolant or fuel ............. Refer to the Lubricating Oil Contaminated symptom tree. OK Go To Next Step STEP 6 Lubricating oil leak (external) ............. Inspect the engine for external oil leaks. Tighten the capscrews, pipe plugs, and fittings. Replace gaskets, if necessary. Refer to Section V for specifications. OK Go To Next Step STEP 7 Lubricating oil level is above or below specification ............. Check the oil level. Add or drain oil, if necessary.

Refer to Section 5. Use the oil recommended in Section V. OK Go To Next Step STEP 8 Electronic fault codes are active ............. For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. OK Go To Next Step STEP 9 Lubricating oil pressure switch, gauge, or sensor is Check the oil pressure switch, gauge, or sensor for correct operation and location. Refer to the OEM service manual. malfunctioning or is not in the correct location ............. OK Go To Next Step