Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-62 Section TS - Troubleshooting Symptoms Smoke, White — Excessive Cause Correction STEP 1 Starting procedure is not correct ............. Verify the correct starting procedure. Refer to Section 1. OK Go To Next Step Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal symptom tree. STEP 2 Engine is cold ............. OK Go To Next Step STEP 3 Engine is operating at low ambient temperature ............. Check the winterfront, shutters, and under-the- hood air. Use under-the-hood intake air in cold weather.
Refer to Cold Weather Operation, Bulletin 3387266, and Section 1. OK Go To Next Step STEP 4 Electronic fault codes are active ............. For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. OK Go To Next Step STEP 5 Starting aid is malfunctioning ............. Check for correct operation of cold-starting aid. Refer to Cold Weather Starting Aids in Section 1. Refer to the manufacturer's instructions. OK Go To Next Step STEP 6 Coolant temperature is below specification ............. Refer to the Coolant Temperature is Below Normal symptom tree.
OK Go To Next Step STEP 7 Fuel grade is not correct for the application or the Operate the engine from a tank of high-quality fuel. Refer to Fuel Recommendations and Specifications in Section V. fuel quality is poor ............. OK Go To Next Step Check for loose or damaged piping connections and missing pipe plugs. Check the turbocharger and exhaust manifold mounting. Refer to Section 4. STEP 8 Air intake or exhaust leaks ............. OK Go To Next Step