Cummins — 4021531

Normal Starting Procedure QSB4.5 and QSB6.7 Page 1-2 Section 1 - Operating Instructions Do not operate a diesel engine where there are or can BE COMBUSTIBLE vapors. These vapors can be sucked through the air intake system and cause engine acceleration and over speeding that can result in a fire, an explosion, and extensive property damage. Numerous safety devices are available, such as air intake shutoff devices, to minimize the risk of over speeding where an engine, due to its application, is operating in a combustible environment, such as due to a fuel spill or gas leak. Remember, Cummins Inc. has no way of knowing the use you have for your engine.

The equipment owner and operator ARE responsible for safe operation in a hostile environment. Consult A Cummins® Authorized Repair Location for further information. WARNING CAUTION Do not expose the engine to corrosive chemicals. Corrosive chemicals can damage the engine. Cummins recommends the installation of an air intake shutoff device or a similar safety device to minimize the risk of overspeeding when an engine is operating in a combustible environment, such as due to a fuel spill or gas leak. Normal Starting Procedure General Information Do not depress the accelerator pedal or move the accelerator lever from the idle position while cranking the engine.

This can result in engine overspeed and severe damage to the engine. WARNING CAUTION To prevent damage to the starting motor, do not engage the starting motor for more than 30 seconds. Wait 2 minutes between each attempt to start (electrical starting motors only). NOTE: Engines equipped with air starting motors require a minimum of 480 kPa [70 psi]. Disengage the driven unit, or if equipped, put the transmission in neutral. With the accelerator pedal or lever in the idle position, turn the key switch to the ON position, and wait for the WAIT-TO-START lamp to go out; then, turn the key to the START position. If the engine does not start after three attempts, check the fuel supply system.

Absence of blue or white exhaust smoke during cranking indicates no fuel is being delivered.