Cummins — 4021531

QSB4.5 and QSB6.7 Electronic Controlled Fuel System Section 1 - Operating Instructions Page 1-7 Engine Shutdown General Information Allow the engine to idle 3 to 5 minutes before shutting it off after a full-load operation. This allows adequate cool down of pistons, cylinders, bearings, and turbocharger components. NOTE: For engines equipped with an electronic control module (ECM) ensure the keyswitch is turned off for a minimum of 70 seconds prior to disconnecting the continuous (unswitched) battery power supply. If the unswitched battery power supply is disconnected in less than 70 seconds after the keyswitch is turned off active fault codes and incorrect ECM information can occur.

Turn the ignition switch to the OFF position. If the engine does not shut down, refer to Troubleshooting Symptom (Section TS) in appropriate Operation and Maintenance manual. Failure to follow the correct shutdown procedure may result in damage to the turbocharger and shorten the turbocharger life. CAUTION Electronic Controlled Fuel System General Information The engine control system is an electronically operated fuel control system that also provides many operator and vehicle or equipment features.

The base functions of the control system include fueling and timing control, limiting the engine speed operating range between the low- and high-idle set points, and optimizing engine performance. The control system uses inputs from the operator and its sensors to determine the fueling and timing required to operate at the desired engine speed. The engine control module (ECM) is the control center of the system. It processes all of the inputs and sends commands to the fuel system and vehicle and engine control devices. The ECM performs diagnostic tests on most of its circuits and will activate a fault code if a problem is detected in one of these circuits.

Along with the fault code identifying the problem, a snapshot of the engine's operating parameters at the time of fault activation is also stored in memory. Some fault codes will cause a diagnostic lamp to activate to signal the driver.