Cummins — 4021531

QSB4.5 and QSB6.7 Cooling System Section 5 - Maintenance Procedures at 500 Hours or 6 Months Page 5-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Cooling System General Information WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. NOTE: Never use a sealing additive to stop leaks in the coolant system.

This can result in coolant system plugging and inadequate coolant flow, causing the engine to overheat. The engine coolant level must be checked daily. CAUTION Do not add cold coolant to a hot engine. Engine castings can be damaged. Allow the engine to cool below 50°C [120°F] before adding coolant. On applications that use a coolant recovery system, check to make sure the coolant is at the appropriate level in the coolant recovery tank for the engine temperature. Many coolant recovery/expansion tanks, also called "top tanks", have sight glasses (1) or are made of a clear material ( not shown) to aid in checking the coolant level (2) without removing the radiator cap.

It is important to understand the impact of temperature on the expansion of the coolant. Most "top tanks" do not have a provision for a "FULL HOT" coolant level. Filling the "top tank" while hot will result in a low operating level once the system has cooled.