Komatsu — 24.5 EVERY 100 HOURS SERVICE

24. SERVICE PROCEDURE 24.5 EVERY 100 HOURS SERVICE WARNING Be sure to put a warning tag on work equipment control levers 1 . Maintenance for every 50 hours should be carried out at the same time. 24.5.1 LUBRICATING WARNING Apply the parking brake, and lock the front and rear frames with the safety bar and pin. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the work equipment control levers. 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that is pushed out.

NOTICE In the extremely hard working conditions, grease the following pins 1 through 6 every 10 hours of operation or daily, whichever way is deemed appropriate. 1. Bucket pin (2 points) 2. Bucket link pin (2 points) 3. Lift arm hinge pin (2 points) 4. Bucket cylinder pin (2 points) 5. Tilt lever pin (1 point) 3-53