24. SERVICE PROCEDURE 24.5.2 CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING When the oil filler cap is removed, oil may spurt out, so stop the engine and wait for the oil temperature to go down, then turn the cap slowly to release the internal pressure before removing the cap. If oil has been added to above the H mark, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. 1. Lower the bucket horizontally to the ground and stop the engine. Wait for 5 minutes, then check sight gauge G . The oil level should be between the H and L marks. NOTICE Do not add oil if the level is above the H line.
This will damage the hydraulic equipment and cause the oil to spurt out. 2. If the oil is below the L level, open the inspection cover above the step and add oil through oil filler port F . For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 24.5.3 CLEAN ELEMENT IN AIR CONDITIONER FRESH AIR FILTER (IF EQUIPPED) WARNING When using compressed air, wear safety glasses and other things required to maintain safety. If the air conditioner has been used, the air filter should be cleaned. Stop the air conditioner before cleaning the element. 1. Hold knob 1 and open cover 2 . 2. Loosen screw 3 , then take out element 4 and clean it. 3.
Blow dry compressed air (max. 0.69 MPa (7 kgf/cm 2 , 99.4 PSI)) along the folds from the inside of the element. Next, blow air along the folds from the outside, then blow from the inside again. REMARK When assembling the element again, install so that the arrow on top of the element is facing the inside of the cab. 3-55