Komatsu — 24.7 EVERY 500 HOURS SERVICE

24. SERVICE PROCEDURE 24.7.5 CHECK FAN BELT FOR WEAR Check the V-belt and when the following conditions exist, re- place or adjust the V-belt. When the V-belt makes contact with the bottom of the groove in each pulley. When the V-belt is worn, and its surface is lower than the outer diameter of the pulley. When the V-belt is cracked or flaked. When the V-belt makes an abnormal noise. Since an auto-tensioner is installed, the V-belt does not need to be replaced until it is replaced. For details of the replacement procedure, refer to “24.2 WHEN REQUIRED”. 3-66