. OPERATION OPERATION CHECK OIL LEVEL IN POWER TRAIN CASE (INCL. TRANSMISSION, TORQUE CONVERTER AND BEVEL GEAR CASES), ADD OIL WARNING (F):Front of the machine 3 - 78 The u ndercover is heavy. Do not go directly under the cov er when opening or closing it. When re moving bolts (5), carry out the operation at the rear of the point imm ediately under the c over so that it is possible to escape at a 1. Start the e ngine and run at id ling for 5 minutes, t hen check the oil level wi th the COLD side of dipstick (G). cloth. Remove d ipstick (G), and wi pe the oil off with a 2. Fully inser t dipstick (G) into f iller pipe (F), then r emove it. 3.
The oil lev el should be betwe en the H and L ma rks on dipstick ( I G). f the oil le vel is below the L mark, add oil throu gh oil filler (F). 4. I f the oil le vel is above the H line, drain oil as fo 1) Remo ve 2 bolts (4) at the front of the machi ne. 2) Hold d own the cover (3) and gradually rem ove 2 bolts (5) at the rear of the machin e. 3) Cover (3) is fitted with a h inge pin at the fron t, so gradually lower cover (3).