Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION Machines equipped with air suspension seat Fore-and-aft adjustment: 190 mm (10 mm x 19 stages) (B) Adjusting seat angle Amount of adjustment Forward tilt: 3 degrees Rear tilt: 11 degrees (F) Adjusting reclining angle 3 - 85 Adjustments (C), (D), and ( K) use the air compressor built i nto the seat, so turn the engine s tarting switch to the ON position. NOTICE There is danger of damage to the air compressor, so do not keep lever (3) operated continuously for (A) Fore-and-aft adjustme Pull lever (1) up, set the se the lever.

Move lever (2) up, move t he seat cushion at the front up o to set to the desired positi (C) Adjusting seat height t uses an air system, and it can be adjusted steplessly. The seat height adjustmen t uses an air system, and it can When adjusting the height , pull lever (3) up fully or push it down fully (when pulling it up, p ull it until a click is felt). When the seat is set at the desired height, release the lever. If the lever is kept pulled up , the position where the seat does not rise any furth er is the maximum height. Whe n the seat reaches the maximum height, the suspension automatically goes down s lightly to secure the amount of movement of the lever.

If the operator raises his bo dy from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension m ay be discharged. mm (3.2 in) Amount of adjustment: 80 (D) Setting seat for weight To protect the operator, it i s necessary to adjust the suspension to match the operator's we ight. When carrying out this adjustment, stop the m achine, set the seat to the correct posture, then operate the lev er. Pull up lever (3) lightly a sh ort distance. The weight settin g is adjusted automatically.

(Th e air pressure inside the suspension is increased o r decreased to match the operator's weight.) (E) Fore-and-aft adjustme Operate lever (4) up, set th e seat cushion to the desired p Fore-and-aft adjustment: 6